8 axis automatic winding machine

图1大.jpgMechanical properties:
High quality resin sand casting
The base plate is welded with steel plate, bearing large, reducing noise and reducing noise, and increasing the stability of the machine.
Imported guide rail and screw, to ensure that the positioning of the machine and the accuracy of repeated positioning
Each step of the assembly of high speed spindle passes through strict quality control, high speed, low noise and long service life.
Type of replacement is convenient, need to invoke the appropriate procedures and support can replace the fixture
Frame detection devices in place can be detected is not in place of the skeleton, and timely alarm and shutdown, ensure that the needle was not interrupted
The needle rod adopts imported mold steel made of full length parallelism and perpendicularity <0.01mm, <0.01mm.
Main configuration:
1, using the Japanese servo motor, imported silk, guide rail.
2, using the Japanese SMC cylinder, Japan's small gold wells pneumatic solenoid valve.
3, using the Japanese Kean fiber sensor, Japan's OMRON photoelectric switch, Japan SMC magnetic switch.
4, the main shaft using the Japanese NSK high speed bearings, the use of Japan's Samsung belt.

Specification parameter

Spindle spacing


Number of principal axis


Spindle direction

Clockwise/counter clockwise/360

Control axis


Spindle speed


D stroke

X:85   Y:85   Z:55

Spindle servo motor power


Applicable line diameter

0.02~0.5(Increasing the power of the motor can be applied to larger diameter)

supply voltage

AC 220V±10%



Max frame outside diameter


compressed air


Host size


Host weight